RF Walk-Test Setup

Set up the radios for a test, then load the firmware and settings onto each device over USB.

Test plan

Edit plan

Radio settings (same for every device in the test)

Slots

Share

Send the link to whoever sets up the devices; it opens this page with the plan filled in. Every device in a test must be set up from the same plan.

Set up devices

  1. Plug the device into this computer with a USB-C cable, using the USB-C port on the ESP32 board (not the micro-USB port).
  2. Click Set up next to the device. In the pop-up, pick the port (usually “USB JTAG/serial debug unit”) and click Connect.
  3. Wait for the green tick — about a minute. Unplug it, then do the next device.
Technical log

Everything this page did, for troubleshooting. If something goes wrong, copy or download it and send it along — it's kept even if you reload the page.